Quality Control Coordinator

Who we are? The Primary Construction Team consists of ACCIONA Infrastructure Canada Inc. (ACCIONA) and Amico Major Projects Inc. (Amico), as Trillium Guideway Partners (TGP). What is the project? The Ontario Line (“OL”) is a fully integrated, stand-alone, rapid transit system that connects Ontario Science Centre to the Exhibition and Ontario Place grounds. The Northern Civil, Stations and Tunnel (“NC”) project consists of approximately 7 kms of underground subway and elevated guideway, with stations along the segment providing connections to surface bus and streetcar routes. The NC project has been divided into two main progressive design-build contracts: (1) the Elevated Guideways and Stations Contract (“EGS”) and the Pape Tunnel and Underground Station Contract (“PTUS”), with supporting Early Works. What is the Opportunity? The Precast Quality Coordinator is responsible for supervising and verifying all quality-related activities during the fabrication of precast concrete elements at the manufacturing facility. This role ensures that all materials, processes, and finished products comply with approved Inspection & Test Plans (ITPs), shop drawings, and project specifications. The coordinator will work closely with the factory production team, design representatives, and third-party inspectors to ensure that precast elements meet all the requirements before shipment to site. Responsibilities Supervise and perform inspections throughout all stages of precast fabrication, including reinforcement installation, formwork setup, concrete batching, pouring, curing, demolding, and finishing. Verify that all activities are carried out in accordance with approved ITPs, drawings, and project specifications. Check and verify the certifications, qualifications, and accreditations of workers, subcontractors, and equipment to ensure alignment with project requirements. Ensure implementation of hold and witness points in coordination with Quality Lead and third-party inspectors. Review and verify raw material certifications (e.g., concrete mix design, rebar mill certificates, embedded items). Monitor concrete production parameters including temperature, slump, air content, and curing conditions. Conduct dimensional checks and surface finish inspections of precast units prior to release. Ensure traceability of materials, mix batches, and element serial numbers from fabrication to delivery. Identify, document, and report Non-Conformances (NCRs) and ensure corrective actions are implemented effectively. Review and maintain all factory quality records including inspection reports, test results, checklists, and calibration certificates. Coordinate with Design and Construction teams to address design changes, construct ability issues, and quality-related concerns. Support factory personnel through training and guidance on inspection procedures and quality standards. Liaise with third-party inspection agencies and ensure timely scheduling and witnessing of tests. Perform pre-delivery inspections to confirm that precast products are properly finished, labelled, and stored for transport. Promote continuous improvement and contribute to lessons learned and best practice sharing within the fabrication team. Participate in quality audits at the precast facility, preparing necessary documentation, records, and evidence to demonstrate compliance with project specifications and quality management system. Organize and lead quality-related meetings at the precast facility to communicate quality findings, reinforce importance of adherence to quality standards, and facilitate collaboration across all departments. Work Conditions Full time – Precast facility at Rodney near London Ontario You’ll bring to the Team (Knowledge, Skills, Competencies) A minimum of 3 years of experience in construction management or supervision within the wet utilities sector. Experience in precast fabrication is highly considered. Has the qualifications demonstrated by certificates of training and experience on transit construction projects. In-depth knowledge of construction processes, materials, and industry best practices. Proficiency in reviewing and interpreting project specifications, drawings, and Inspection & Test Plans. Experience with quality inspection tools, testing methods, and documentation practices. Familiarity with relevant regulatory requirements, codes, and construction standards. Ability to identify, document, and manage Non-Conformances and corrective actions. Clear and professional communication skills, both written and verbal. Ability to work collaboratively with multidisciplinary teams, contractors, and stakeholders. Please note that only candidates that meet requirements will be contacted. We do not accept unsolicited agency resumes. We are committed to creating an accessible and barrier‑free recruitment process and workplace. If you need any accomodation throught the process, please email